Machine Settings

i2 model-specific machine settings and calibration parameters.

Typical operator flow

1. Power on and complete the safety reset.

2. Load the required recipe (tray format).

3. Confirm tooling, film, and utilities are correct.

4. Wait for temperatures to reach setpoint.

5. Start production.

6. Monitor alarms and product quality.

7. Stop safely and isolate services when required.

HMI pages and what they’re for (typical)

Screen names vary by software version. The purpose is usually consistent.

• Home / Overview: machine state, mode selection, warm-up status.

• Run / Production: Start/Stop, live counters, cycle status.

• Recipe / Product: load, save, and edit recipe parameters.

• Setup: format setup prompts and guided checks.

• Manual / Jog: manual moves and I/O checks for trained users.

• Alarms: active alarms, alarm history, and recovery prompts.

• Maintenance: service timers, lubrication counters, planned tasks.

• Machine settings (restricted): machine constants and calibrations.

• Diagnostics (build dependent): sensors/I-O, drives, comms, logs.

If your HMI uses different labels, follow the top navigation icons. Look for the same function groups.

Where to find it on the HMI (typical)

1. Present RFID tag (Engineer level).

2. Navigate to Settings → Machine settings.

3. Select the relevant category.

i2 machine settings (model-specific)

Document what differs from other i-Series machines. If a value is build dependent, note the range and the as-built default.

Motion and timing

• Transfer arm positions and timing: TBD

• Infeed/outfeed speed limits: TBD

• Tray pitch limits: TBD

Sealing station

• Tool lift stroke limits: TBD

• Seal platen offsets: TBD

• Temperature limits and scaling: TBD

Film system

• Unwind torque defaults: TBD

• Film snap / tension thresholds: TBD

• Register mark sensor setup (if fitted): TBD

Options and integrations

• Gas flush configuration: TBD

• Vacuum cycle enable: TBD

• Printer integration (if fitted): TBD

Service and diagnostics

• Service interval timers: TBD

• Network / remote support parameters (if fitted): TBD